part colour typ. fwd max fwd forward max rev typical luminous typical chromaticity viewing number voltage voltage current current intensity coordinates angle vf@lopr vf@lopr lopr lr(vr=5v) lv@lopr @lopr 2?? standard intensity 100044 blue 3.6 4.0 20 50 2300 0.13 / 0.075 15 units water clear v v ma ua mcd x / y deg 100044 series ? high intensity ? also available as a 5mm device ? solid state reliability ? can be supplied in bulb replacement and panel mounting formats discrete leds - ? 3mm blue ? marl optosource 2006 : ds 100044 issue 1 telephone +44 (0)1229 582430 ? fax: +44 (0)1229 580012 ? email: sales@optosource.com ? website: www.optosource.com the information contained in this datasheet does not constitute part of any order or contract and should not be regarded as a r epresentation relating to either products or service. marl international reserve the right to alter without notice the specification or any conditions o f supply for products or service. ordering information & typical technical characteristics (ta = 25c) * duty cycle <= 1/10, pulse width <= 10msec optical/electrical characteristics (ta = 25c) part colour forward peak fwd reverse power dom operating storage number current current voltage dissipation wavelength temp temp lopr max lfp * vr max p dmax typ. d topr tstg standard intensity 100044 blue 30 100 5 120 470 -30 to +85 -40 to +100 units water clear ma ma vdc mw nm c c absolute maximum ratings (ta = 25c) precautions for handling electrostatic sensitive leds static electricity and surge static electricity and surge will damage the led and a high standard of care must be taken during handling. it is recommended that a wristband, conductive mat or anti-electrostatic glove is used when handling the leds. all devices, equipment (e.g. soldering iron points) and machinery must be properly grounded. safety precautions for handling high brightness leds the light output of the products may cause injuries to human eyes in circumstances where they are viewed directly with unshielded eyes for more than a few seconds. please refer to european standard bsen 100015-1 1992 for further information. dimensions in mm (typical) tolerance +/- 0.2 uos not to scale 1.5 max anode 1.0 2.5 0.5+/-0.5 3.5 2.0 27.5+/-1 11.0+/-0.5 6.0 5.0 0.75 max ?3.1 ?3.8
|
